C Hanging The Lamp - Brandt AD786XE1 Guide D'utilisation

99636141_ML_A.qxd 25/02/05
A
ssembling the chimney
Hood to be used with external evacuation:
- Remove the two attachment clips provided for the transportation of the chimneys.
- Remove the two attachment screws from the plastic deflector (in recycle mode only).
- Attach the metal chimney bracket to the wall, also placing this against the ceiling (fig. 6).
Take care in aligning the 2 triangular slots on the metal bracket with the vertical line on the wall.
- Assemble the back flow valve at the motor outlet (fig. A). This back flow valve permits bloc-
king of airflow from outside.
- In the case of a flue with a diameter of 125 mm, use the adapter supplied (fig. 8/fig. B).If your
exterior duct is below 125 mm, you must obligatorily connect your hood in
recycling mode
- Prepare your telescopic chimney taking care to block off the vents (fig. 8).
Fit the chimneys into one another as far as they will go.
- Fit the upper part to the metal bracket.
- Adjust the length of the telescopic chimney by bringing down the lower part and fitting it to the
top of the hood.
Hood to be used in "recycling" mode: f
- It is possible to remove the back flow valves.
- Fit the plastic smoke deflector to the wall also placing this against the ceiling.
Take care to centre the deflector vis-à-vis the vertical line drawn on the wall
(fig. 7)
- Prepare your chimney taking care to place the vents toward the top to ensure that
they are visible
- Fit the upper part to the plastic deflector.
- Adjust the length of the telescopic chimney by bringing down the lower part and fitting it into
the top of the hood.
C
hanging the lamp ?
1. Remove the viewing port (fig. 11).
2. Change the halogen lamp
3. Replace the lamp assembly by carrying out the above operations in reverse order.
10:18 Page 6
To ensure optimal use of your device, we advise that you connect a flue with a
diameter of 150 mm (not supplied). Limit the number of angles and bends as
far as possible, and keep the length of the flue to a minimum. In the event
that the hood will be functioning using exterior evacuation, you should ensure
a sufficient inlet of fresh air to avoid a pressure deficiency in the room.
.
(fig. 9)
.
Before carrying out any work, the power supply to the hood must be turned off,
either by unplugging it or by using the circuit breaker switch,
G4-20W-12V.
fig. 4 and 8
ig. 5 and 9