Rehau G2 Mode D'emploi page 28

5. Insert joint fully into clamp ing tool.
Caution:
Do not tilt. Tool must be applied over full surface and at right angles.
6. Insert the compression sleeve all the way up to the fitting collar by acti-
vating the pressure switch / foot lever.
Processing at temperatures of under -10°C and over 50 °C may result in
damage to the joint components, the tool and/or in personal injury .
- Do not work below the minimum processing temperature of -10 °C .
- At low temperatures (below 0 °C), it is recommended that the
joint components be stored in a warm environment before
processing .
Please observe also the instruction leaflet of the compression sleeves
110x10!
28