TEMPUR-PEDIC ERGO Manuel Du Propriétaire page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

safety precautions and usage statements
Product Ratings:
The lift motors are not designed to operate continuously for more than two
[2] minutes in an eighteen [18] minute time period or approximately 10% duty
cycle. Attempting to circumvent or exceed this rating will shorten the life
expectancy of the product and may void the warranty.
The massage motors are not designed to operate continuously for more
that 30 minutes at a time. Please allow the massaging system to rest for 30
minutes after automatic massage shut off before restarting.
Weight Limits:
The recommended weight limits on the TEMPUR-PEDIC ERGO
SLEEPTRACKER
SYSTEM are:
®
Twin Long / Full / Queen / King / Split CA King / CA King: 700 pounds.
Maximum weight the bed can support per person is 275 pounds with the
weight evenly distributed across the head and foot sections. This product
is not designed to support or lift this amount of weight in the head or foot
sections alone. NOTE: Exceeding the recommended weight restrictions could
damage your TEMPUR-PEDIC ERGO
your warranty. For best performance, you should enter and exit the TEMPUR-
PEDIC ERGO
+ SLEEPTRACKER
TM
lowered position.
TEMPUR-PEDIC ERGO
+ SLEEPTRACKER
TM
bed frames, furniture beds and platform beds that are certified to hold a
minimum of 900 pounds. If using this adjustable base without the legs
and placing directly on a bed frame or platform bed, cross-bed supports
(slats) are strongly recommended to ensure TEMPUR-PEDIC ERGO
SLEEPTRACKER
SYSTEM maintains stability during operation.
®
Exceeding this weight restriction could damage the bed
and/or cause injury and will void the warranty.
Acoustics:
In normal base operation the wheels, which allow the bed to maintain its
distance from the wall, will make contact with the steel platform supports of
the base creating a contact noise. When entering, exiting or shifting weight
on the base, this contact noise may be audible as the wheels make contact.
This is normal.
2
+
TM
+ SLEEPTRACKER
SYSTEM and void
TM
®
SYSTEM while it is in the flat or fully
®
SYSTEM fits easily inside
®
+
TM
Fabric Care:
To prolong the life of your fabric, protect from direct sunlight whenever
possible. For spot cleaning, wipe area with a light damp sponge or vacuum
with a soft brush attachment to remove particles. Keep at a minimum of
30cm (12 inches) away from direct heat sources.
For deeper cleaning, blot liquid spills with a clean dry cloth. Wipe with a clean
cloth dampened with warm water. Do not wet excessively. A soft bristle brush
may be used to remove ingrained soil. Avoid scratching by gentle brushing.
Wipe with a clean cloth dampened with warm water to remove residues after
brushing. Dry in shade away from direct heat.
If persistent marks remain visible after cleaning, seek professional advice.
FCC Compliance:
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
To comply with the FCC RF exposure compliance requirements, no
change to the antenna or the device is permitted. Any change to the
antenna or the device could result in the device exceeding the RF
exposure requirements and void user's authority to operate the device.
Radio Frequency: 2.4 GHz
CAN ICES-3 (B)/NMB-3(B)
Tempur-Pedic
Sleeptracker
System
®
®
For Tempur-Pedic Ergo™
System Components
Sleeptracker Sleep Monitoring System Model STS-40:
- One Sleeptracker Processor Units
- One or two Sleeptracker Sensors*
Sleeptracker Smart Cable Model STC-10
Quick Start Card with QR code
Safety and Warranty Information

Publicité

Table des Matières
loading

Table des Matières