Cleaning Reminder; Cleaning The Oven Door - Electrolux EOZ5700 Notice D'utilisation

Masquer les pouces Voir aussi pour EOZ5700:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Do not start the Pyrolysis if:
– You did not remove the shelf
support or telescopic runners (if
supplied). In some models, the
display shows "C1" when this
error occurs.
– You did not remove the core
temperature sensor plug from
the socket (if supplied). In some
models, the display shows "C2"
when this error occurs.
– You did not fully close the oven
door. In some models, the dis-
play shows "C3" when this error
occurs.
2.
Remove the worst dirt manually.
3.
Touch
again and again until the
display shows "Pyro" and the number
of the cleaning mode.
4.
Touch
or
of the cleaning procedure:
– 1 – 1:00 for a low degree of dirt
– 2 – 1:30 for a usual degree of dirt
– 3 – 2:30 for a high degree of dirt.
Touch
to activate the Pyrolysis
function.
Useful information:
You can use the End function to delay the
start of the cleaning procedure.
During the Pyrolysis the door is locked.
The symbol
and the bars of the heat
indicator come up, until the door unlocks.
The door unlocks when the temperature
inside the oven is under safety conditions
and the Pyrolysis finishes.
During the cleaning procedure the lamp is
deactivated.

Cleaning reminder

To remind you that the Pyrolysis is neces-
sary the cleaning reminder symbol
flashes in the display after each deactiva-
tion of the appliance for the next 10 sec-
onds.
The cleaning reminder goes
out:
• After the end of the Pyrolysis
function
• When you deactivate it in the
Basic settings (refer to "Basic
settings")
to set the duration
11.2 Oven lamp
WARNING!
Be careful when you change the
oven lamp. There is a risk of elec-
trical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or
deactivate the circuit breaker.
Put a cloth on the bottom of the
oven to prevent damage to the
oven light and glass cover.
Always hold the halogen lamp
with a cloth to prevent grease res-
idue from burning on the lamp.
1.
Turn the glass cover counterclock-
wise to remove it.
2.
Clean the glass cover.
3.
Replace the oven light bulb with an
applicable 300 °C heat-resistant oven
light bulb.
Use the same oven lamp type.
4.
Install the glass cover.

11.3 Cleaning the oven door

The oven door has four panels of glass in-
stalled one behind the other. You can re-
move the oven door and the internal glass
panels to clean them.
CAUTION!
Do not use the appliance without
the glass panels.
The direction in which you open
the door depends on your oven
model. You open the door from
the right side in some models and
from the left side in others.
ENGLISH
25

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Eov5700

Table des Matières