Install Backsplash - KitchenAid Commercial-Style KXW9736YSS Instructions D'installation

Install Backsplash

1. Hook the fl ange on the back of the Backsplash over the mounting brackets attached to the wall.
2. Center the Backsplash and align the three holes at the bottom of the Backsplash with the marks on
the wall made in the "Mark Guide Lines" section.
3. Attach bracket to wall using the three 10-12 x 2" screws through the holes at the bottom of the fl ange.
Install Shelf
The shelf included with the backsplash can be installed in two different positions.
1. Locate the hinge pin in each end of the shelf. View into the slot on either end of the shelf and the
hinge pin is visible.
SHELF ENDCAP
SLOT
SHELF (REAR VIEW)
2. Grasp the shelf on each end with the shelf in the desired orientation.
3. Align the slots of the shelf with the shelf brackets and insert the hinge pins into the shelf bracket slot.
4. Slide shelf back until both hinge pins on each end are positioned into notch of the bracket.
HINGE PIN
SHELF
(UPRIGHT POSITION)
HINGE PIN
BRACKET
SLOT
SHELF MOUNTING
BRACKET
BRACKET
NOTCH
BACKSPLASH
4
WALL