Lighting The Stove - Dometic ORIGO A100 Notice D'utilisation

_Origo_A100_A200_C100_C200.book Seite 17 Freitag, 13. Februar 2009 7:33 19
Dometic ORIGO
➤ Replace the canister.
Check that the stovetop gets level and is not blocked in any way.
➤ Close the stovetop until the magnetic lock engages.
8.2

Lighting the stove

➤ Turn the control knob counter-clockwise to the ignition position.
✓ The built-in 12 V lighter is activated and the burner is ignited. Depending
on temperature and the canister filling level, the time required may vary.
Note
I
If the voltage of the built-in 12 V lighter is insufficient, light the stove
by placing a long match or a long lighter to the burner opening
(fig. 0, page 6).
Quickly remove your hand as soon as the burner ignites.
➤ Adjust the flame so it does not extend beyond the edge of the pot.
➤ Choose the desired power setting via control knob.
Note
I
If the stove hasn't cooled down from previous use, the burner may
ignite but immediately extinguish. In this case blow air into the
burner opening to dissipate vapour.
Afterwards light the stove as described above.
8.3 Extinguish the flame
➤ Turn the control knob to the Off position.
✓ The burned is closed.
➤ Wait about five seconds.
➤ Turn the control knob to the Maximum position to make sure the flame is
extinguished.
✓ The burner is open.
➤ Turn the control knob to the Off position.
✓ The burner is closed.
➤ If applicable, wait until the stove has cooled down completely before re-
placing the glass lid.
Using the stove
17