Dometic ORIGO A100 Notice D'utilisation page 15

_Origo_A100_A200_C100_C200.book Seite 15 Freitag, 13. Februar 2009 7:33 19
Dometic ORIGO
➤ Mark the drill holes.
Use the fastening holes in the hinge as a template.
➤ Pre-drill the holes into the countertop where marked.
➤ Fasten the stove by screwing flat head screws through each drill hole in
the hinge (fig. 5 2, page 4).
➤ Install the magnetic locker in the front of the cutout (fig. 4 1, page 3).
➤ Connect the built-in lighter's terminal connection (fig. 5 1, page 4) to
12Vg.
➤ Place a class B-1 fire extinguisher in reaching distance.
7.3 Connecting the stove electrically
(Dometic ORIGO C100 and C200 only)
Warning! Danger of injury!
e
The stove may only be connected by a qualified specialist.
The following information is intended for technicians who are
familiar with the guidelines and safety precautions to be applied.
Observe the following safety instructions for the electrical connections:
Warning, risk of short circuit!
e
Always use sockets which are grounded and secured by
residual current circuit breakers.
If you have to feed cables through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
Fasten the cables securely.
Do not pull on the cables.
Lay the cables so that they cannot be tripped over or damaged.
➤ Check the type plate on the right side of the stove to ensure that the volt-
age of the unit matches the voltage of the source.
➤ Connect the three conductors of the connection cable to the AC mains.
➤ Secure the cable with a clamp.
Mounting the stove
15