Electrical Connections; Initial Lighting - Dometic PI7078 Notice D'utilisation Et D'installation

EN IT
3. INSTALLATION
3.4

Electrical connections

WARNING
Before proceeding make sure the appliance is disconnected from the mains power
supply.
The electrical specifications of the appliance are shown below:
Rated voltage
220-240V~ 50/60Hz
WARNING
For the direct connection to the mains power supply, a device must be fitted to
assure disconnection from the mains power supply, with a contact aperture that
allows complete disconnection in the conditions of overvoltage category III, in
compliance with installation regulations.
If a socket is used to connect the appliance to the mains power supply, the plug must
be accessible after installation.
The power cable must be positioned in such a way that no part of it reaches 75°C
above room temperature.
Always disconnect the mains power supply before working on the appliance.
WARNING
If the power cable (H05RR-F 3x2.5 mm
it replaced by the manufacturer, the technical service centre or by a person with
similar qualifications.
3.4.1

Initial lighting

Excessive lighting when making electrical connections will switch on all the LED's, all the displays and lock all
the controls.
When the direct lighting is switched off the appliance will revert to normal operation.
22
Rated power
2900 W
) is damaged, for reasons of safety have
2