GB
IE
1. Place the device with the bottom edge
ofthefootplate(17)ontheworkpiece.
2. Turn on the device.
3. Insertthesawblade(20)intheworkpi-
ecebytippingthedeviceforwarduntil
the device is vertical.
4. Continuesawingalongthedesiredcut-
ting line.
Selection of sawblade
Wood sawblade
Metalsawblade
Plunge sawblade
Motor unit with
multifunction tool
PKGA4
Wearaprotectivemaskduring
grindingwork.
Changingthetool
Secure the appliance against
switching on (see "Switch
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Ensurethatthetoolholder(29)is
tightly screwed in to ensure you can
safelymountanduseallthesup-
pliedtools(30/32/33).
1. Pushthelever(27)fortoolunlocking
upwardsasfarasthestop.
2. Placethedesiredtool(30/32/33)be-
lowthetoolholder(29)onthearbors
40
forwood,plastic,plaster-
board
formetalsheets,profiles
and tubes
forsoftmaterialslike
woodorplasterboard
(28).Youmayneedtorotatetheun-
lockedtoolholder(29)asfarasneed-
edtoallowyoutoplacethedesired
tool(30/32/33)ontothearbors(28).
12differentpositionsarepossible.
3. Rotate the tool holder as required until
itisfirmlyinplace.
4. Pushthelever(27)fortoolunlocking
forwards again. The tool holder is
fixedtothetool.
Attaching/removingsanding
sheet
Thedeltasandingplate(30)isfittedwith
Velcroforrapidattachmentofthesanding
sheet.
Attaching sanding sheet
1. Pressthesandingsheet(31)evenly
ontothedeltasandingplate(30).En-
sure that the holes in the sanding sheet
areplacedabovetheopeningsinthe
sandingplate.
Removing sanding sheet
2. Simplypullthesandingsheet(31)off
thedeltasandingplate(30).
Sanding
• Movetheapplianceagainstthework-
pieceonceitisswitchedon.
• Cleanthesandingplatebeforeyouat-
tach a sanding sheet.
• Onlyworkwithsandingsheetsinper-
fect condition to achieve good sanding
results.
• Workusinglowandevenpressure.
Thisprotectstheapplianceandthe
sanding sheet.
•
Do not use the same sanding sheet to
sanddifferentmaterials(e.g.metal
andthenwood).