Connections - Pioneer DRM-1004 Mode D'emploi

CONNECTIONS

Before making or changing the connections, switch off the power switch and disconnect the power cord from the AC outlet.
With this unit, each of the drives and Changer mechanism controller is equipped with a special SCSI controller and a couple of external SCSI
connectors. This makes it possible to connect them with free SCSI wiring according to the user's operating environment and to control each
drive and Changer independently.
Caution in connection:
Make sure that the SCSI ID and terminator of each drive have been
set properly
When daisy chain connection is used, connect the drives and Changer
so that the Changer becomes the terminating device, set the terminator
SW of each drive to OFF, set that of the Changer to ON, and assign
SCSI IDs so that they are not overlapped.
NOTE:
When setting the SCSI IDs, be careful not to leave the pointer arrow
of the SCSI ID switch between two figures; be sure to set the switch
so that the arrow points a single figure.
When connecting each drive or chain individually to a SCSI controller,
set all of the terminator SWs to ON.
The changer's SCSI ID switch and the terminator switch are on the
back. For the drive, refer to the instruction manual for the drive you
are using.
Equipped with 4 drives
120V
230V
100V
SIGNAL
GND
Equipped with 4 drives
Host computer
l
Drive 1
l
Drive 2
l
Drive 3
l
Drive 4
l
Changer
Term switch
OFF
OFF
OFF
OFF
ON
9
<DRC1129>
En