VDO AcquaLink Notice D'utilisation page 50

Getting started
Configure the display
Following are the steps for initial configuration:
1. When turned on, indicate the type of boat and number of engines.
2. Set up general device operations (see "General settings" on page 57 and "System settings" on
page 59).
3. Configure the sensors connected to Nav Box (see "Sensor configuration" on page 65).
4. Change/remove data pages selecting the best layout and data to be viewed (see "Data page
configuration" on page 53).
5. Enable/disable the alarms on the VDO CAN bus, NMEA 2000 and SAE J1939 networks (see "Alarm
management" on page 62).
50 7" TFT display | Operating instruction v. 1.0 | © 2018 Continental Automotive Switzerland AG