Steba HF 5000 XL Mode D'emploi page 17

Operation
∙
Never use the device without the basket. Place the food into the basket and
not into the pot.
∙ Clip the basket into the pot and slide both parts into the device. To remove the
basket, pull out both parts and place on a heat resistant surface. By pressing the
button on the handle, you can separate the basket from the pot.
∙ Unwind the cable from the cable storage and plug it in. the device beeps and the
display shows - - - in blue.
∙ Pre-heat the device for 2 minutes, fill the basket up with food and insert it to the
device.
∙ Fill the basket up to ¾ in order to avoid any burns on the food and leave space to
turn the food.
∙ By pulling out the pot from the device to control the degree of doneness, the heat-
ing is interrupted, time is stopped too.
∙ After the time run out, take out the pot and place it on a heat resisting surface.
∙ By pressing the basket locking you can detach the basket and take out the food.
∙
If the pot and the basket are used together to take out the food,
for seasoning etc., do not press the basket locking!
∙ In order to achieve an even browning of the food, turn or shake the food. Do not
use any metallic objects for turning the food.
∙
The pot and basket get very hot!
Fil the basket only up to the max marking in order
to avoid any burns on the food.
∙
∙ Press the temperature button
and 15 minutes.
∙ Those values can be changed within 10 seconds by:
o Pressing the temperature button once again. 180°C is flashing, with the
control dial you can set the temperature in steps of 5°C from 80°C to 200°C.
o Pressing the timer button
dial from 1 to 60 minutes.
∙ By pressing the start button the device starts working and time begins to count
down. The display shows a ventilator symbol. The red dot in the centre of the venti-
lator clocks as soon as the temperature is reached.
∙ During operation, the temperature and time can be changed.
∙ If the basket is pulled out of the device during operation, the timer stops and re-
starts again as soon as the basket is inserted again.
. The display shows the default setting of 180°C
the time can be changed with the control
17