Technical Information; Installation Considerations - Hansgrohe Axor Downpour 28494 Série Instructions De Montage / Mode D'emploi / Garantie

Tools Required / Outiles Utiles /
Herramientas Útiles
17 mm
2
12 mm
27479xx1
only
English

Technical Information

Recommended water pressure
Max. water pressure
Recommended hot water temp. 120° - 140° F*
Max. hot water temp
Showerhead flow rate
04718xx0 only
28494xx1 / 28484xx1 2.5 GPM (9.5 L/min)
/27493xx1 / 27474xx1 / 27476xx1
* Please know and follow all applicable local plumb-
ing codes when setting the temperature on the water
heater.

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The showerheads are for use with an automatic
compensating valve rated at 2.0 GPM
(7.6 L/min) or less.
• 04718xx0 only: This showerhead is for use
with automatic compensating valves rated at
1.7 GPM (6.4 L/min) or less.
If you install
#27413xx1, #27422xx1, or #27479xx1
shower arm with optional Axor wall
plate #34612xx1,
#36725xx1, follow the installation
instructions included with the wall plate.
• To prevent scald injury, the maximum output
temperature of the shower mixing valve (not
included) must be no higher than 120°F. In
Massachusetts, the maximum output temperature
can be no higher than 112° F.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product
in a safe place. The receipt is required should it
be necessary to request warranty parts.
15 - 75 PSI
145 PSI
176°F*
2.0 GPM (7.6 L/min)
the #27412xx1,
#27419xx1, or