Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Installation
Supplies Required:
• Pipe sealant
• Piping to 1" NPT water supply inlet
• Adequate supply pipe supports
• Minimum 4" (102 mm) drain to accommodate 30
gallons (115 liters) per minute discharge for shower
waste
• Sign-mounting hardware
Step 1: Assemble components
1. Assemble the components as shown on page 4.
• Apply pipe sealant to all male-threaded pipe
joints.
• Bottom edge of showerhead should be 84"
(2134 mm) from the floor.
Step 2: Connect water supply
IMPORTANT: Do not rely on Bradley's
Drench Shower to support supply piping.
1. Connect water supply piping to 1" NPT inlet
on unit (piping supplied by installer). Provide
adequate supports (supplied by installer) for
supply pipe using pipe hangers or other means.
2. Mount the safety sign to the wall using sign-
mounting hardware supplied by installer.
Bradley • 215-279 Rev. J; ECN 12-05-016A
(400mm)
3¾"
(95mm)
1½"
(38mm)
84"
(2134mm)
to Floor
9"
(229mm)
5/25/2012
S19-120SS
15¾"
3
⁄
"
5
8
(92mm)
25½"
(648mm)
3
Publicité
Table des Matières
