Installation Instructions; Prepare Built-In Oven; Remove Oven Door(S) - Whirlpool WODA7EC0HZ Instructions D'installation

Prepare Built-In Oven

1. Decide on the final location for the oven. Avoid drilling
or cutting into house wiring during installation.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the oven onto cardboard prior
to installation. Do not use handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
Remember to keep the corner posts and other materials
that may be needed for installation.
4. Remove the hardware package from inside the bag
containing literature.
5. Remove and set aside racks and other parts from
inside the oven.
6. Move oven and cardboard close to the oven's final location.

Remove Oven Door(s)

IMPORTANT: Use two hands to remove oven door. For double
ovens, repeat the process for each door.
1. Prior to removing the oven door, prepare a surface where
you will place it. This surface should be flat and covered
with a soft blanket, or use the corner posts from your
packaging material.
2. Fully open the oven door.
3. Locate the oven door hinge locks in both corners of the
oven door, and rotate the hinge locks toward the oven door
to the unlocked position. If the door hinge lock is not rotated
fully (see illustration B), the door will not remove properly.
Locked
position
Grip here
to rotate.
A. Oven door hinge lock in
locked position

INSTALLATION INSTRUCTIONS

Door
hinges
Unlocked
position
B. Oven door hinge lock in
partially unlocked position
4. Gently start to close the door. The door will stop at a partially
closed position.
5. Using two hands, grasp the edges of the oven door. Close
the oven door slightly past the stop position to take the
weight off of the door hinges, and then pull the oven door up.
6. Pull the oven door toward you, and then remove. You may
need to gently shift the door from side to side as you pull.
7. Set the oven door aside on the prepared covered work
surface with the oven door resting on its handle.
8. To continue with the oven installation, go to the
"Positioning Oven Feet for Multiple Cabinet Cutout
Heights" section.
7