Energy Saving - LAVAZZA LB COMPACT Mode D'emploi

EN
The manufacturer will not be responsible for any
damage due to the following:
– Improper use or any other use not provided
for.
– Repairs made by unauthorized service cen-
tres.
– Power cord tampering.
– Machine component tampering.
– Use of spare parts and accessories other than
the genuine ones.
– Troubles caused by limestone.
– Storing at a temperature of less than 4° C.
– Using the machine at a temperature of less
than 5° C.
– Using the machine at a temperature of more
than 40° C.
– Using pods other than the Lavazza BLUE ones.
In the above cases, the product warranty will be
null and void.
GETTING THE MACHINE TO WORK
Place the machine onto a stable, flat surface,
far from water and heat sources. The machine
shall never be covered with cloths or any other
object when it is working.
1
engaging position on the machine.
2
3
14
GETTING THE MACHINE READY
4
The water level shall never exceed the MAX lev-
el and shall always be above the MIN mark. Use
only fresh, drinkable and non-effervescent wa-
ter, hot water or any other fluid that might
damage the tank.
Do not start the machine when water has not
been filled; moreover, make sure that the wa-
ter level is above the minimum level shown.
Make sure that your hands as well as the cord
and the machine supporting surfaces are not
wet.
5
Fit the supply plug into the power outlet.
6
Press the main switch on the machine left side.
Now the heating phase will start and both sup-
ply buttons will flash. After the heating phase
is over, the machine will notify its own 'Ready'
state by causing both supply buttons to light up
steadily. Now the machine will be ready for use.
Pressing the main switch one more time will
cause the machine to be turned off.

ENERGY SAVING

After 30 minutes' idle time, the machine will en-
ter the energy saving mode and the boiler sup-
ply will be disconnected.
Both supply buttons will always be ON.
To start the machine again, proceed with the ordi-
nary preparation of product.