Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11 Disposal
Fault
Pilot arc does not ignite
Main arc does not ignite
Torch body or power
source cable overheating
Pilot or main arc is burning
skewed
Wire feed not working
Tab. 12
Troubleshooting
11 Disposal
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards and guidelines.
EN - 22
Cause
• Tungsten electrode and plasma
nozzle make contact
• Distance between tungsten
electrode and plasma nozzle too
large
• Tungsten electrode is worn out or
oxidised
• Distance between the workpiece
and the torch too large
• Pilot arc does not burn
• Inadequate coolant flow
• Welding current too high
• Coolant hose or liquid-cooled
power cable constricted or
sealed
• Tungsten electrode worn out
• Plasma nozzle worn out
• Centring ceramics missing
• Plug not connected properly
ABIPLAS
Troubleshooting
• Re-adjust the electrode
• Re-adjust the electrode
• Re-sharpen and align the
electrode
• Shorten the distance
• Ignite the pilot arc
• Check and repair
• Reduce the welding current
• Remove constriction and replace
cable assembly if necessary
• Sharpen the tungsten electrode
• Replace the plasma nozzle
• Replace the centring ceramics
• Connect the plug
• Check electrical connection
BAL.0128 • 2019-09-04
®
WELD CT
Publicité
Table des Matières
