Häfele WT 200 Instructions De Montage Et De Maintenance page 61

Installation and maintenance instructions - English
1. Notes on these
installation and maintenance instructions
1.1 Contents and
target group of
the installation
and maintenance
instructions
1.2 Obligations of
the installer
1.3 Obligations of
the operator
These instructions are intended to facilitate the safe mounting and installation of the
WTC 200 controller (referred to throughout this document as "the controller") as well
as the WRU 200 and WRU 220 wall readers (referred to throughout this document
as "the readers") as part of an access control system.
The instructions are part of the system and must be kept in the immediate vicinity of
the system and be accessible for the personnel at all times.
The personnel must read and understand these instructions carefully before starting
any work. A basic requirement for safe work is the observance of all safety notes
and handling indications specified in these instructions.
Furthermore, the local health and safety regulations and general safety regulations
for the area of application of the system apply.
Associated documents
In addition to these installation instructions, the following documents are valid for the
access control system:
• Supplier documentation of the power supply
• Dialock 2.0 user manual or updated version
It is essential to pay attention to these installation and maintenance instructions in
order to install the product successfully and safely. Please pay attention to all of the
specified installation steps, instructions and notes!
These installation and maintenance instructions are intended for:
• the operator of the product
• the installer of the product
In addition to these installation and maintenance instructions, , both groups of
people must also have read the DIALOCK –- software manual in full before handling
the product.
In case of use in software-controlled systems, separate instructions are enclosed
with the relevant system components.
The installer has the following obligations:
• All notes and specifications in the installation and maintenance instructions must
be complied with. The installation steps must not be deviated from or varied.
• Only the supplied original parts must be installed.
• The installation and maintenance instructions must be handed to the operator
after installation has taken place.
The operator has the following obligations:
• The installation requirements must be adhered to.
• The product may only be installed and started up by qualified experts.
• The installation and maintenance instructions must be kept until the product is
disposed of, and handed to the new operator in the event of a change of operator.
61