After Installation - Häfele WT 200 Instructions De Montage Et De Maintenance

5.5 After installation

90
1. Establish the voltage supply.
2. Check function.
The installation was performed correctly, if the following
is true:
Controller (for LEDs see Fig. 30):
• LEDs for power supply light up
(LED 15, 16, 17).
• All LEDs for the open input contacts light up
(LED 10, 11, 12, 13).
• The LEDs for the closed input contacts do not light up
(LED 10, 11, 12, 13).
• The LEDs for the RS-485 interfaces do not flash
(LED 1, 2, 4).
• The network connection LED lights up
(yellow LED at network connection "A").
Configuration and start-up
The system configuration and the configuration of the Micro SD
cards take place via the software and are carried out by the
system supplier's customer service. The initial start-up of the
access control system is also carried out by the system supplier's
customer service.
More information about the start-up and configuration of the
SD card and the overall system can be found in the Dialock 2.0
user manual.
LEDs on the WTC 200
Fig. 30: Overview of LEDs on the WTC 200 controller
1-17 LED 1–17
A Network connection