General Information - Novy MA7510 Instructions D'installation

GENERAL INFORMATION

General
These are the mounting instructions for the Novy unit shown on the cover. The user manual is delivered separately with
this unit. Carefully read these instructions before installing and commissioning this unit. It is recommended to have one
or more qualified persons carry out the installation.
This manual makes use of a number of symbols. The meaning of these symbols are given below.
Symbol
Safety
Observe the following mounting and safety tips for mounting:
• The installation and electrical connection of the unit shall be carried out by an authorised expert.
• The manufacturer does not accept any responsibility for any damage resulting from faulty building in or connection.
• Carefully take the unit from the packaging and check it for damage before mounting.
• Do not mount the unit in case of any damage.
• Check if all mounting materials have been supplied using the drawings at page 2.
• The unit is intended for household use only (preparation of food) excluding any other domestic, commercial or in-
dustrial use.
• Safety can only be guaranteed if the unit is connected to an earth wire in accordance with the required regulations.
• Do not use an extension cord for connecting to the electricity grid.
• Replace defective or damaged parts only with original Novy parts.
• Replace a damaged power cable with an original Novy power cable.
Important before mounting
Page 2 of these mounting instructions show the mounting drawings. Observe the following mounting tips before starting
the mounting activities:
• For easier mounting of the ceiling unit, it is recommended to do this with at least 2 persons.
• Make sure that the ceiling has sufficient load bearing capacity.
• Position the electrical connection such, that it is located behind the mounting plate.
InTouch
InTouch offers the option to control the Novy cooker hood from the Novy InTouch induction hotplate. The ceiling unit
may, as a default, be combined with InTouch induction hotplates. Visit the website for the different models of induction
hotplates with InTouch
INSTALLATION
Follow the mounting drawings on page 2.
1
Attaching the mounting plates:
- The mounting holes can be marked by using two drilling jigs.
- Mark the central line of the drilling jigs. Make sure that the hood is mounted in the centre over the cooking plate.
- The distance between the mounting points of the two mounting plates is 940 mm or 470 mm measured from the
central line.
In view of the substantial own weight of the hood, the ceiling must have sufficient load bearing capacity.
Bear in mind that the electrical connection must be placed behind the right-hand mounting plate.
2
Attach each of the mounting plates with four screws unto the ceiling. Here pay attention to the position of the elec-
trical connection.
3
Carefully remove the hood from the packaging.
Install the hood such, that the operating panel is on the right-hand side.
Position the hood at a certain height, making sure that the mounting cables can easily be placed. Take the ends of
Meaning
Indication
Warning
Action
Explanation of an indication on the
hood
This symbol indicates an important tip
or a dangerous situation.
EN 12