General Information - Novy 811400 Instructions D'installation

GENERAL INFORMATION

These are the mounting instructions for the product shown on the cover. Carefully read these instructions before installation
and commissioning. It is recommended to have one or more qualified persons carry out the installation only.
Carefully remove the content from the packaging and check the materials. Do not use sharp knives to open the packaging.
In case of damage, immediately contact your dealer.
The hood with Monoblock filter must be installed above a hob and/or domino's, and is intended for domestic use only.
INSTALLATION
1. Open the lower plate of the built-in unit and
2. Remove the grease filter from the built-in unit.
3. Place the Monoblock filter in the opening provided for it in the hood.
Put the grease filter back in the built-in unit and close the lower plate.
CAUTION! Keep the exhaust free. Opening (with or without grille) in cabinet or chimney with a minimum surface area of
123 cm² for models 810 and 811.
PROGRAMMING CLEANING INDICATION
Programming (the motor must be disabled):
Simultaneously press + and – for 5 seconds until the red LED flashes 5 times. The following functions have now been
enabled:
• The run-out time has been set to 30 minutes (instead of the default 10 minutes). Make use of the 30 minutes run-out
time.
• The cleaning indication for the Monoblock filter has been set to 200 operating hours.
The red LED will light after 200 operating hours. This indicates that the Monoblock filter needs cleaning (see the instructions
below).
Inactivate the programming (the motor must have been switched on):
Simultaneously press + and – for 5 seconds until the 3rd green LED flashes 5 times.
CLEANING THE MONOBLOCK FILTER
The red LED will light up after 200 working hours (time to regenerate the Monoblock filter). The Monoblock filter can be
found behind the grease filter. The Monoblock filter can be regenerated up to 12 times.
Regenerating the Monoblock filter:
• The Monoblock filter can be regenerated up to 12 times. This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C. Provide sufficient fresh air in the room where the oven has been placed,
as smells can be released. Smells can be released when baking certain kinds of fish. The best solution for this is to
immediately regenerate the filter.
Reset (the motor must be switched on):
Simultaneously press + and – for 5 sec. until the red indicator lamp flashes 3 times for confirmation. If the programming
is not carried out, the programming is automatically set after the hood has been switched on 10 times.
All manuals and user guides at all-guides.com
EN 8