Programming A New Smartkey; Operate; Operating Your Smartdoor - Petsafe PPA11-10711 Guide D'emploi

C. Programming a New SmartKey
To reduce error while programming, remove the RFA-67 battery from all programmed SmartKeys
except the one you are programming. Press and hold the LEARN button until the green light
illuminates and begins to fl ash, now release the button. Bring the SmartKey
green light and the light will stop fl ashing and illuminate for two seconds. Now your new SmartKey
has been programmed and added to memory. Up to fi ve different SmartKeys
a time.
D. Attach the SmartKey
A split key ring has been provided to attach to your pet's
collar and should hang under the pet's neck.
The SmartDoor includes (one) SmartKey
™
pre-programmed and ready to use.

OPERATE

Operating Your SmartDoor

LOCKED MODE – Does not allow entry or exit for any pet. The SmartDoor
in LOCKED MODE and when batteries are placed in the SmartDoor
set: hold the MODE-RESET button until the red light illuminates and release when selected.
UNLOCKED MODE – Allows entry and exit for all pets. To set: hold the MODE-RESET button until
the green light illuminates and release when selected.
AUTOMATIC MODE – Allows entry and exit for a pet wearing a programmed SmartKey
to fi ve SmartKeys
™
automatic mode. To set: hold the MODE-RESET button until the yellow light illuminates and
release when selected.
NOTE:
If at any time the red light remains illuminated, replace with a set of fresh batteries. If that
does not reset the red light, please call our Customer Care Center for additional help.
Illuminating Color
RED
GREEN
YELLOW
RED, GREEN AND YELLOW
SmartDoor does
™
not respond to the
presence of the
SmartKey when my
™
pet is directly in front
of the SmartDoor
™
within three seconds
to the Pet's Collar
™
can be programmed into one SmartDoor
Condition
Solid only for two seconds after
selecting LOCKED Mode
Flashing
Constant solid
Solid only for two seconds after
selecting UNLOCKED Mode
Flashing
Solid only for two seconds after
selecting AUTOMATIC Mode
Flashing
Flashing at the same time
Troubleshooting
• Check that the SmartDoor
• Check that the SmartKey
• Check sensitivity level has been properly set, see page 10.
• Check that the RFA-67 battery in the SmartKey
• Check that the batteries in the SmartDoor
• If the condition persists, check that there are no radio-frequency
transmitting devices or electronic devices that radiate electrical
energy, which may interfere with the operation of the SmartDoor
™
which comes
™
™
is in AUTOMATIC Mode.
™
has been programmed to the SmartDoor
™
www.petsafe.net
directly below the
™
can be added, one at
™
ships from the factory
™
, it will enter LOCKED MODE. To
™
for selective entry and exit during
™
Pet Door Status
LOCKED Mode
Low battery alert
Internal failure has occurred
UNLOCKED Mode
Learn Mode
AUTOMATIC Mode
Error alert
Sensitivity Test Mode
is screwed in tightly.
™
are fresh.
™
™
™
; up
™
.
™
.
™
11