Setting Smartdoor ™ 'S Sensitivity Level; Set; Understanding Sensitivity And The Active Area - Petsafe PPA11-10711 Guide D'emploi

NOTE:
The SmartDoor
SmartKey is detected. Do not allow your pet to run or charge through the SmartDoor
™
variable radio-frequency interferences it could take several seconds for SmartKey
to read properly and SmartDoor

SET

A. Setting SmartDoor
It is necessary to set your SmartDoor
due to location or application material, such as radio-frequency interferences, wood or metal
door installations.
To begin, it is recommended to use the split ring (included) to attach the SmartKey
on your pet's collar. Also do not use metal tags as the additional metal can cause radio-frequency
interference and hinder the detection of your pet's SmartKey
"product in use" steps:
1. Put the dog's collar on your leg just below your knee. Tape
may be used to secure the collar, if necessary. See A.
2. Stand directly in front of the SmartDoor
is approximately 2.5 feet (76 cm) from the SmartDoor
3. Put the SmartDoor
for operational instructions).
4. Put the SmartDoor
holding down the MODE-RESET and LEARN buttons at the
same time until all three lights fl ash once.
5. Turn the Sensitivity Knob counter clockwise to the
minimum position, then turn the Sensitivity Knob
clockwise until all lights begin to fl ash again.
6. Slowly continue to adjust the Sensitivity Knob clockwise
until you see a minimum of six consecutive fl ashes and
stop adjusting. Do not adjust higher than necessary.
7. Put the SmartDoor
at least 10 feet (3 m), allowing the door to automatically
lock. This may take up to fi fteen seconds after the
SmartKey no longer is detected.
™
8. Now confi rm the sensitivity level by approaching the
SmartDoor again. The door should unlock when you
™
step within approximately 2 feet (60 cm) in front of the
SmartDoor .
™
B. Understanding Sensitivity and the
Active Area
The Active Area is the area where the SmartDoor
consistently open based on your adjustment of the
sensitivity level. In the Fringe Area the SmartDoor
open inconsistently due to variables of radio-frequency
interferences or refl ections. In the Inactive Area the door
will generally not unlock automatically. See B.
You may see slight differences between Outside and Inside
Active Areas due to radio-frequency interferences.
10
is designed with an electric motor to release and unlock fl ap when a
™
's fl ap to unlock.
™
's Sensitivity Level
™
's sensitivity level so your pet's SmartKey
™
in the UNLOCKED Mode. (See page 6
™
in the Sensitivity Test Mode by
™
in AUTOMATIC Mode and step away
™
Depending on location
and application
~ 2.5 feet (76 cm)
~ 6 feet (183 cm)
1-800-732-2677
so the SmartKey
™ ™
.
™
will
™
may
™
™
. Now, continue with the following
™
A.
B.
Door - Top View
Outside Inactive
Fringe
Active
Active
Fringe
Inside Inactive
. Due to
™
's unique code
™
works properly
to the D-ring
™