Revert Smartkey; Clear Smartkey Memory; Replacement Parts And Accessories; Customer Care International - Petsafe PPA11-10711 Guide D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Yellow light is fl ashing
Red light remains
illuminated (internal
failure has occurred)
Red light is fl ashing
Red, green and yellow
lights are fl ashing

Revert SmartKey

The SmartDoor
can be cleared of all additional programmed SmartKey
from the factory. To do this, fi rst take out batteries from battery compartment. Then, as you place
batteries back into the battery compartment, hold down the LEARN button. When LEARN button
is held and the last battery is in place, the red and green lights will illuminate three times. Now,
all SmartKeys
programmed to the SmartDoor
included with your SmartDoor
Clear SmartKey
The SmartDoor
can be cleared of all programmed SmartKeys
factory. To do this, fi rst remove batteries from battery compartment. Then, as you place batter-
ies back into the battery compartment, hold down the MODE-RESET button. When MODE-RESET
button is held and the last battery is in place, the red and yellow lights will illuminate three times.
Now all SmartKeys
______________________________________________________________________________

Replacement Parts and Accessories

To purchase replacement parts for your PetSafe
at 1-800-732-2677 or visit our website at www.petsafe.net to locate a retailer near you.

Customer Care International

Canada: 1-800-732-2677
United Kingdom: 0800 046 1414
Europe: 00 800 18 18 20 20
Component
SmartKey
PetSafe
RFA-67 Battery
®
Small Replacement Flap
Large Replacement Flap
Small SmartDoor
Large SmartDoor
Small Wall Conversion Kit
Large Wall Conversion Kit
Large Extension Tunnel
Small Wall Conversion – Hardware Replacement Kit
Large Wall Conversion – Hardware Replacement Kit
12
• Obstruction to the flap has been detected.
• Press the MODE-RESET button to cause the SmartDoor
to lock the flap. Clear any obstructions that keep the flap from
locking. When the flap successfully locks, normal operation is resumed.
• If your large SmartDoor
an additional magnet kit to help center flap due to constant wind
or a variance between indoor and outdoor pressure. Please call the
Customer Care Center for further assistance.
• Remove batteries and replace them with a fresh set of batteries. If
that does not reset the red light, please call Customer Care Center at
1-800-732-2677 for additional help.
• Low battery indicator, replace batteries.
• Sensitivity set mode has been activated. It will automatically
de-activate in thirty minutes, or can be immediately de-activated by
pressing the MODE-RESET button once.
to Default Factory Setting
.
Memory
have been cleared.
Hardware Kit
Hardware Kit
does not close properly, you can purchase
have been cleared except the one SmartKey
SmartDoor
®
Australia: 1800 786 608
New Zealand: 0800 543 054
Part Number
PAC11-11405
RFA-67
CPA11-11580/MPA00-12830
CPA11-11579/MPA00-12829
CPA00-11617/MPA00-12814
CPA00-11618/MPA00-12815
MPA11-12019
MPA11-12020
CPA00-12021/MPA00-12820
CPA00-12054/MPA00-12821
CPA00-12055/MPA00-12822
1-800-732-2677
EXCEPT the one included
, even the one included from the
, contact the Customer Care Center
to attempt

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ppa11-10709Smartdoor ppa11-10711Smartdoor ppa11-10709

Table des Matières