Rowenta Perfect Steam Mode D'emploi page 13

normally but remember to rinse the boiler
before you use it again.
IMPORT NT! This operation must
not be carried out unless the steam
station has been unplugged for at
least two hours and has cooled down
completely.
• Place the steam station on the edge of
your sink, with the iron placed to one side,
standing on its heel.
• Unscrew the boiler rinse cap cover anti
clockwise for a quarter of a turn - fig. 22.
• Using a coin, gently unscrew the boiler
rinse cap - fig. 23.
• Holding the steam station in a tilted
position, and using a jug, fill the boiler
with ¼ litre of untreated tap water -
• Shake the base unit for a few moments -
fig. 25 and then empty it completely into
your sink - fig. 26.
US : If this troubleshooting does not resolve the issue, before consulting the retailer
or returning the product, please telephone Rowenta Consumer Services at 1-800-769-
3682. Further hints ans tips are obtainable from our homepage www.rowentausa.com
Canada : If you are unable to trace the cause of the fault, contact an official Rowenta
Customer Service Center. The addresses are shown in the enclosed service center
address list. Further hints and tips are obtainable from our homepage:
www.rowenta.ca
IS THERE
Problems
The steam station does
not switch on or the iron
indicator and ON/OFF
indicator do not switch on.
Water runs through the
holes in the soleplate.
PROBLEM?
Possible Causes Solutions
The appliance is not
switched on.
You use steam too
frequently when your iron
is not hot enough.
Water has condensed in the
pipes because you are using
steam for the first time or
you have not used it for
some time.
• To obtain the best results, we recommend
that this operation is done twice.
• Screw back and tighten up the boiler rinse
cap with a coin -
• Put the boiler rinse cap cover back in place
- fig. 28.
The next time you use the station
press the "restart" button to turn off
the orange light.
The steam station does not work
without the scale collector / boiler
rinse cap (according to model).
Regular descaling of your steam
station helps to maintain its steam
performance over time
fig. 24.
Check that your appliance is correctly
plugged in and press the illuminated on/off
switch.
Wait for the thermostat light to go out before
activating the steam button.
djust the frequency of use of the steam
trigger to match the position of the
thermostat (see § 6).
Press on the steam control button away from
your ironing board until the iron produces
steam.
13
fig. 27.