sylvac VISIO 300 GL Mode D'emploi page 7

3 QUICK START RUNNING SYLVAC-REFLEX VISTA
3.1
Starting
up
2 Turn on the machine using the On/Off
3 Start running the software and get the main
4 The XYZ-counter lines show *----*, telling
5 Position the workpiece to be measured in
1 Start the computer.
SYLVAC-REFLEX Vista
connected.
switch located on the right side.
window as pictured below.
you that the coordinate axes must be
initialized. Move each axis until each
counter shows a numerical value, passing
through the midpoint (X- and Y- axes) as
well as the upper point (Z-axis).
the middle of the glass plate.
Make sure the
6 Move Z-axis until you get a sharp image,
dongle is
and set the light sources for optimum edge
detection.
A
A Diascopic illumination
B Episcopic, ring-shaped, illumination
C Coaxial light
7 Now
investigate the many functions of the
SYLVAC- REFLEX Vista software.
8 When you have finished, save your
program. This will allow you to re-use it later
as required.
To find out more about the SYLVAC-REFLEX
Vista software and your SYLVAC-VISIO 200
GL, please refer to the appropriate instruction
manuals from the DVD provided with each
feature.
B
you can start measuring
C
and
7