Mounting Instructions - Marmitek TMD4 Guide Utilisateur

In this way Marmitek X-10 modules can be switched or dimmed
remotely via the electric main and Macros in the computer interface
can be activated.
Red: Input 2, second address
Same as input 1, only for 'address + 1'
Orange: input 3, third address
Same as input 1, only for 'address + 2'
Yellow: input 4, fourth address
Same as input 1, only for 'address + 3'

MOUNTING INSTRUCTIONS

Warning! Always switch off the main master switch before
installing the MicroModule.
To install the TMD4 you need the following wires at the module
installation point.
• When present take the switch out of the wall outlet.
• Disconnect the wires from the switch.
• Pull an additional Neutral wire in case this one is missing.
TMD4™
Neutral
Phase 230V
9