Marmitek TMD4 Guide Utilisateur page 12

Address and options can be programmed with any Marmitek X-10
controller or remote control. In the following example we start
programming with the help of Marmitek EasyControl8 remote
control (when you start programming with a RF remote control like
the Marmitek EasyControl8 don't forget to use a TM13 transceiver
as well so that the commands of the Marmitek EasyControl8 are
placed on the electric main.
Example of programming of the address E4:
• Set up your remote control (see manual Marmitek
EasyControl8 remote control) and Marmitek X-10 TM13
transceiver to house code E.
• Switch the MicroModule in setup mode.
• Press the Marmitek X-10 button (house) of the Marmitek
EasyControl8 remote control and then button number 4.
• Press the ON button twice.(= prog+)
• The MicroModule responds by flashing the LED twice.
• The E4 address is programmed now.
Example of programming the ALL UNITS OFF function
• First program the desired address !! (e.g. E4).
• Leave the remote control and the TM13 Transceiver on house
code E or set up in this house code.
• Switch the MicroModule in setup mode.
• Press the ALL OFF button twice.
• The MicroModule responds by flashing 8x with the LED.
NOTE !
• In program mode always program the address first and then
the other optional functions.
• On receipt of a new address during program mode the optional
functions are re-set to the standard set-up.
• The TMD4 can not send ALL LIGHTS ON or ALL UNITS OFF
itself. It can only receive this signal and based on this adjust its
internal status. (So next time somebody presses the button the
TMD4 must send an ON command.
• Due to heat generation, apply no more than one module per
flush socket / central socket!
12 © MARMITEK