Video Picture Setting - ABUS Security-Center EYSEO TV7300 Instructions D'installation

9.5 Video picture setting (PICTURE)
This menu is used for the perfect setting of the video signal with the help of a video monitor or
oscilloscope. The settings have a strong impact on the video picture. The factory settings are
optimised for 80% of all applications. You are recommended to keep the factory settings. To
change the settings in the submenus, use the RIGHT/LEFT keys to navigate to the desired menu
item and then press ENTER. The following submenus are provided:
VIDEO: Here you can change the settings for the average chroma for improving the colour signal-
to-noise ratio, the colour depth (hue), the brightness, the pedestal (black level), the SPRS effect
and the SPRS gain.
APERTURE: Here you can fine-tune the vertical and horizontal lines, thus optimising the picture
clarity.
GAMMA: Here you can make a gamma correction to adjust the camera for different display types
(TFT monitor, tube monitor, etc.). This is made possible by an extended dynamic range with knee
circuit.
This submenu applies to VIDEO mode:
Program the camera as follows:
VIDEO MENU
BRIGHT
PEDESTAL
RETURN
1. Move the cursor to select BRIGHT. Looking at the monitor or oscilloscope, adjust the
brightness of the picture by using the LEFT/RIGHT keys to enter a value.
2. Move the cursor to select PEDESTAL. Looking at the monitor or oscilloscope, adjust the
pedestal by using the LEFT/RIGHT keys to enter a value. Use a high pedestal for
insufficient illumination.
41
90
7.5IRE