ABUS Security-Center EYSEO TV7300 Instructions D'installation page 36

This menu applies to the WD MODE operating mode.
Program the camera as follows:
WD MENU
MODE
AGC
RETURN
1. Move the cursor to select "MODE" and change the settings with the LEFT/RIGHT keys. You
can select between six options:
INDOOR1 – INDOOR2 – INDOOR3 – INDOOR4 – OUTDOOR1 – OUTDOOR2 – ENGINEER
INDOOR1: This mode is suitable for large rooms with strong daylight.
INDOOR2: This mode is suitable for long corridors and entrance halls with little daylight.
INDOOR3: This mode is suitable for areas with strong light contrasts.
INDOOR4: This mode is suitable for areas with strong light contrasts.
OUTDOOR1: Use this mode for monitoring a light area from a dark area
(such as vehicle registration monitoring or underground garage).
OUTDOOR2: Use this mode for monitoring a dark area from a light area (such as the
entrance to an underground garage).
ENGINEER: This mode is for programming by the manufacturer only.
INDOOR1
07
AGC: Move the cursor to select "AGC" (automatic gain control) and change the settings with the
LEFT/RIGHT keys. The higher the value, the lighter the image in bad light conditions, but also the
greater the noise.
36