SCHOLTES CJ 32G W Mode D'emploi page 21

Mounting the legs Mounting the le Mounting the le Mounting the le Mounting the le gs gs gs (only on certain models) gs
Press-fit legs are supplied which fit under the base of your cooker.
Installing the Cook Installing the Cooker Installing the Cook Installing the Cook Installing the Cook
The appliance can be installed next to cabinets, provided they are not taller than the hob. If the cooker is placed in contact
with walls or the sides of adjacent cabinets, they must be capable of withstanding a rise in temperature of 50°C above
room temperature. For proper installation of the cooker, the following precautions must be taken:
a) Kitchen cabinets installed next to the cooker that are higher than the top of the hob, must be at least 600 mm from
the edge of the hob itself.
b) Hoods must be installed according to the requirements in the installation manual for the hood and, in any case, at a
minimum height of 650 mm.
c) If the hood is installed below a wall cabinet, the latter must be at least 700 mm (millimetres) above the surface of the
hob. Cabinets installed adjacent to the hood must be at least 420 mm above the hob, as shown in Figures C and D.
Making the Gas Connection Making the Gas Connection Making the Gas Connection Making the Gas Connection Making the Gas Connection
The appliance should be connected to the mains or to a gas cylinder in compliance with current directives. Before making
the connection, check that the cooker is regulated for the gas supply you are using. If not, follow the instructions indicated
in the paragraph "Converting to Different Types of Gas." On some models the gas supply can be connected on the left or
on the right, as necessary; to change the connection, reverse the position of the hose holder with that of the cap and
replace the gasket (supplied with the appliance). When using liquid gas from a cylinder, install a pressure regulator which
complies with the National Regulations.
Important: Check that the supply pressure complies with the values indicated in table 1 "Burner and Nozzle Characteristics"
since this will ensure safe operation, correct consumption and ensure a longer life for your appliance.
Connection with a Hose Connection with a Hose
Connection with a Hose Connection with a Hose Connection with a Hose
Make the connection using a gas hose that complies with requirements set forth by the current standards. The inner
diameters of the pipe are as follows:
- 8 mm for liquid gas;
- 15 mm for methane.
When installing the hose, remember to take the following precautions:
• No part of the hose must come into contact with parts whose temperature exceeds 50°C;
• The length of the hose should be less than 1500 mm;
• The hose should not be subject to twisting or pulling, and should not have bends or kinks;
er er er er
HOOD
600
Min. mm.
Fig. C
HOOD
900
Min. mm.
Fig. D
- 21 -