SLV 1000868 Mode D'emploi page 3

ENGLISH
OPERATING MANUAL FOR
OUTDOOR SOCKET
1000868 / 1000869 / 1000870 / 1000871
1000872 / 1000873 / 1000874 / 1000875
1000876 / 1000877 / 1000878 / 1000879
Read this short manual carefully and keep it accessible for further
reference!
SAFETY MESSAGES
Disregard of the safety messages may lead to danger of life, burning or
fire!
 Installation, mounting or works on the electrical connection may only be
carried out by an approved electrician.
 Type Y attachement: If the external flexible cable or cord of this luminaire is
damaged, it shall be exclusively replaced by the manufacturer or a
qualified electrician.
 The cable of the product may not be placed underground.
 The product may not be modified or converted.
 Do not hang or fasten anything on the product, especially no decoration.
 Do not cover the product - provide free air circulation.
 The foot or the base of the product must be kept free and may not be
covered with soil, dirt, leaves, etc.
 Openings providing aeration or drainage may not be covered.
 In case of a malfunction you may NOT touch the product or operate it
further. Disconnect the product from the power supply by an external
switch or by the fuse.
A malfunction exists when:
 visible damages appear.
 the product does not work properly (e.g. flickering).
 smoke, steam or crackling sounds appear.
 smell of burning is recognisable.
 an overheating is recognisable (e.g. by discolouration of adjacent
surfaces).
Operate the product only after maintenance and examination by an
approved electrician!
 This product is not intended to be used by children. Ensure that children do
not suffer any harm e.g. by burns from hot surfaces or by electrical shock.
Additional safety messages are indicated by this symbol:
USE AS DIRECTED
 The Product may only be used as garden socket in the outdoor areas.
 The product may not be exposed to strong mechanical loads or to strong
contamination.
 The use of the product on construction sites or in rough areas is not
allowed.
OPERATION
Safety function: In case of overload the product will automatically cut off. By
pressing the switch (A) the product will be ready for use again.
MAINTENANCE AND CARE
Care
 The following enviromental influences may have unwanted effects on the
surface of the product:
 acid rain and sour soil, high salt content in the air
 cleaning agents, fertilizer especially in flowerbeds
 thawing salt, other chemical substances (e.g. herbicides)
Protect the product by adequate means to avoid unwanted changes of the
surface.
Disconnect the product from the power supply before you clean and
maintain the procuct.
 Clean the product on a regular basis using a slightly moistened, soft and fluff-
free cloth. Please also note additional supplied notes on maintanance and
care.
STORAGE AND DISPOSAL
Storage
 The product must be stored in a dry and clean environment. Do not strain
the product mechanically during storage.
After a damp or soiling storage the product may only be installed after
checking its condition by an approved electrician.
Disposal (European Union)
 Do not dispose the product with the regular household waste! Products
marked with this sign must be disposed according to the directive (WEEE,
2012/19) on electrical and electronic devices at local collection points for such
devices!
INSTALLATION
(only by an approved electrician)
Switch off the mains or respectively the connection lead before doing any
works!
Use only parts, which are supplied with the product or are described as
accessories!
.
Inspect the product for loose parts inside the housing. When there are loose
parts inside the housing and these are not explicitly described the product may
not be installed or operated.
Unpacking
 Carefully take the product out of the packaging removing any transport
safeguards.
 Before disposal of the packaging material make sure that all components of
the product are removed.
Installation place
 The product is solely suited for installation on the floor.
 The foot or the base of the product must be kept free and may not be
covered with soil, dirt, leaves, etc.
The product may only be utilized according to IP44.
IP44: Protection against foreign objects > Ø 1,0mm - Protection against
splashing water from all directions.
Choose a place where the installation is not a danger (e.g. stumbling,
knocking).
Keep a sufficient distance to water areas. Minimum distance: 0,5m
Prepare the power supply lead according to valid rules for outdoor
installations.
Do not seal the product yourself, using additional silicon or another
sealant.
Installation steps (read completely before installation)
 Assemble the product as shown in the figure.
 The earth spike must be anchored in the ground, so that the product
cannot fall down. The ground may not be permanently wet.
 Connect the plug of the product with a suitable outdoor socket (i.e. SLV
art-no. 227000).
Check if the product functions properly and is securely fixed!
art.-no. 1000868 / 1000869 / 1000870 / 1000871 / 1000872 / 1000873 /
1000874 / 1000875 / 1000876 / 1000877 / 1000878 / 1000879 © 07.09.2017
SLV GmbH, Daimlerstr. 21-23, 52531 Übach-Palenberg, Germany,
Tel. +49 (0)2451 4833-0
Technical Details are subject to change.