Operation - Husqvarna CL400 Manuel D'utilisation

Note: Clean and lubricate the housing of the cutter
each time after work.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Before you operate the product
1. Place the cable into the cable winder, adjust the
burial depth and tie the cable end to a stake.
2. People, animals or things should be kept outside the
safety zone of at least 20 meters.
3. Warm up the product before start.
4. Water the ground the day before performing the
work during the summertime or in the presence of
dry soil.
To start the product
Do safety check to the product before starting the
Safety instructions for operation on
product. Refer to
page 4 .
1. Use a funnel to fill the product with fuel. The funnel is
provided with the filter.
Note: The product is supplied with no oil.
2. Move the gas lever to START position when start the
cold engine.
3. Grip the engine starting knob and pull fully.
4. Let the engine warm up for a few minutes to reach
the operating temperature before setting it to the
maximum speed.
5. Lower the cutter rotation clutch completely.
6. Engage the cutter rotation clutch forward fully.
7. Start the work.
WARNING: Pay attention when the product
starts to work.
Danger Perform commissioning work to the
product. The belt should be settled during
the first operation hour. Make sure that the
stretching springs work correctly.
To adjust the blade cutting depth
The knob on the rear of the blade is used to adjust the
cutting depth.
1394 - 002 - 27.11.2019

Operation

1. Loosen the knob (1) a few turns counterclockwise.
2. Raise or lower the support (3) of the two rear
wheels.
Note: The graduated bar (2) on the support side is
used as depth reference. The unit of the numbers on
the graduated bar is centimeters and the depth
range on the graduated bar is from 1 to 6.
3. Tighten the knob (1) clockwise when the support
reaches the necessary depth.
To adjust the cutting speed
The accelerator knob is used to increase or decrease
the engine rotations.
1. Increase the engine rotation to make the cutting
speed faster.
2. Decrease the engine rotation to make the cutting
speed slower.
CAUTION: Do not adjust the speed by
slipping slightly the clutch discs of the
transmission box. This can cause severe
damage to the transmission.
Note: Always pull the forward lever fully until the forward
lever touches the handle.
To adjust the height of the handlebar
The height of the handlebar can be adjusted in 5 levels.
7