Husqvarna CL400 Manuel D'utilisation page 6

2. Install the cable end into the tube of the blade (A)
until the cable comes out from the bottom a few
centimeters (B).
To use the wrapped cable reel
1. Loosen the knob (A).
2. Pull the retainer (B).
3. Remove the winder (C).
6
A B
A
B
C
4. Put the reel on the tube of the winder. Use the
adapter if necessary (D).
5. Assemble the retainer and tighten the knob (E).
To assemble or replace the cutter
Note: 6 mm spanner is needed for assembling and
replacing the cutter.
1. Loosen the retaining screw of the head (A).
2. Remove the worn cutter, if it is installed to the head
(B).
3. Install the new cutter.
4. Tighten the retaining screw.
5. Remove the residues of grass and dirt, if the cutter is
replaced when the product is in operation
Note: Make sure that no residues enter the cutter
during the process of installation.
D
E
A
1394 - 002 - 27.11.2019
B