Use; Using The Control Unit - Nouvag TCM 3000bl Mode D'emploi

TCM 3000 BL - Morcellator
6

Use

Before use
Make sure that the product has been correctly prepared and inspected.
Risk of injury
The TCM 3000 BL - Morcellator control unit has been designed for operation with the morcellation blades
as a set. The user is solely responsible if different products are used with the set. Incompatibility may risk
injury to patients.
Switching on and off
Switch on the control unit. The display lights up. A short signal tone sounds. The control unit displays the
value "200 rpm".
Operating mode (motor)
The motor is designed for intermittent operation (1 minute on, 1 minute off for 8 cycles).
6.1

Using the control unit

Setting the speed
The speed can be set manually in stages (within a
range of 50 to 100 rpm).
Press to increase the speed.
Press to reduce the speed.
The set speed is shown on the display.
Starting motor
Press pedal.
The blade rotates at the set speed.
The motor LED lights up.
To stop the motor remove foot from pedal.
Risk of injury and damage due to heat!
The Morcellator may generate heat if operated for a long period.
Remedy:
Use Morcellator only in intermittent mode of "1 minute on, 1 minute off for 8 cycles".
Stop the Morcellator immediately if one or more components of the Morcellator set become very warm.
Precaution when changing parameters. Unusual behavior of instruments while operating may provoke
false reactions and jeopardize the patient.
Every setting and the new behavior of the instrument has to be verified and tested.
Instrucions for use for TCM 3000 BL - Morcellator, Ref. 31946, V26/16
EN
19