Instruments With Tolerance Indications (Diodes) - Bowers Metrology UniCal 300 Notice D'utilisation

Press quickly the [mode] button to introduce upper tolerance limit.
Refer to chapter V.3 (Introduction of preset value) to introduce the upper tolerance limit.
Keep [mode] button pressed until lower tolerance limit is displayed.
Refer to chapter V.3 for introduction of lower tolerance limit (i.e. preset values).
Keep [mode] button pressed until set indicator is cancelled.
V.5.2 Instruments with tolerance indications (diodes)
The preset tolerance limits will be the references for activating the LED.
The LED will be activated for 5 sec. as soon as the measured value is stable.
This system allows to extend the battery life.
V . 5 . 1 . 2 I N T R O D U C T I O N O F T H E L O W E R L I M I T
V . 5 . 1 . 3 R E T U R N T O T O L E R A N C E M O D E
V . 5 . 2 . 1 H O W T H E L E D A R E W O R K I N G
60 60 60 60