I Instruction For Use For Caliper; I.1 Description Of Instrument; I.2 Measuring - Bowers Metrology UniCal 300 Notice D'utilisation

I Instruction for use for Caliper

I.1 Description of instrument

1. Beam
2. Cover for digital output OPTO-RS
3. Locking screw
4. Multifunctional LCD
5. Moving measuring pin
6. Measuring pin left
7. Mounting attachments for bottom left pin
8. Mounting attachments for bottom right pin
9. [mode] button
10. [set] button (ON/OFF)
11. Pull-out slide for battery compartment
12. Push device

I.2 Measuring

7
For external measurements, the thumb of the righthand should exert pressure on the push device (5) parallel to the beam (1).
To obtain a correct repetability, the pressure on the push device (5) must be constant.
To avoid possible deflection of the beam (1) it is recommended that the operator applies on opposing pressure with the thumb of the lefthand on the jaw (2).
6 5
8 9
4 3 2
10 11 12
51 51
51 51
E
1