Ball Valve; Heat Meter; Transport And Storage; Installation - oventrop Multidis SFQ Notice D'utilisation

"Multidis SFQ"

4.1 Ball valve

Illust. 7: Dimensions ball valve
Item no. Size
1406383 DN 20 G ¾
1406384 DN 25 G 1
1406483 DN 20 G ¾
(with
thermometer)
1406583 DN 20 G ¾
(with
thermometer)
1406484 DN 25 G 1
(with
thermometer)
1406584 DN 25 G 1
(with
thermometer)
- The ball valves 1406483 and
1406484 have a red T-handle
identifying the supply pipe.
- The ball valves 1406583 and
1406584 have a blue T-handle
identifying the return pipe.
The length with installed ball valve is
obtained by adding the length of the
stainless steel distributor/collector
"Multidis SFQ" (L) and the length of
the ball valve (L1).
140485280-V02.08.2019
D L1 L2
55 mm 57 mm
80 mm 60 mm
73 mm 60 mm
73 mm 60 mm
85 mm 60 mm
85 mm 60 mm

Transport and storage

4.2 Heat meter

Standard heat meters G 1 and G ¾ can be
installed.
The dimensions of the heat meter
can be obtained from the heat meter
manual.
5. Transport and storage
The stainless steel distributor/collector has to
be transported in the original packaging.
The stainless steel distributor/collector must
only be stored under the following conditions:
Temperature
-20°C up to +60°C
range
Max. relative 95%
humidity of air
Particles Dry and free from dust
Mechanical Protected from
influences
mechanical agitation
Radiation
Protected from UV-rays
and direct sunlight
Chemical Not together with
influences solvents, chemicals,
acids, fuels and similar
6.

Installation

The brackets allow for the fixing of the
distributor/collector onto the wall or in the
cabinet.
1. Mount the flow distributor (at the top) and
the return collector (at the bottom) into the
sound-absorbing brackets.
2. Fix it onto the wall or in the cabinet.
The supply and return pipe can be
connected from either the left or right
hand side.
EN
25