Wet Vacuum Cleaner With Optional Front Squeegee Kit - Hillyard Trident WD21V Manuel D'utilisation

WET VACUUM CLEANER WITH OPTIONAL FRONT SQUEEGEE KIT WD21V
To start working as a wet vacuum cleaner with the optional front squeegee kit, proceed as follows:
1.Make all the checks indicated in "PREPARING THE MACHINE".
2.Free the vacuum head from the collection tank by releasing the hooks (1) on the side of the tank. Rotate
the levers as shown by the arrow in the picture on the right.
3.Use the handle (2) on the vacuum head unit to remove it from the collection tank.
4.Rest the head carefully on the ground.
5.Make sure the float unit is inserted in the collection tank. If this is not the case, position it correctly.
ATTENTION: there must be no solid
waste residue inside the collection
tank.
6.Use the handle (2) on the vacuum head unit to position it above the collection tank.Make sure the machi-
ne's power supply cable is in the rear part of the tank.
7.Fix the vacuum head to the collection tank by coupling the hooks (1) on the side of the tank. Rotate the
levers as shown by the arrow in the picture on the right.
8.Insert the plug (3) of the power supply cable (4) in the mains socket (5).
9.Switch on the machine by bringing the main switch (6) to the work position "I".
10.Bring the front squeegee into contact with the ground by lightly pressing downwards on the squeegee
command pedal (7) then moving it to the left just enough to release it from its restraint.
11.Carry out the cleaning work.
ATTENTION: if the vacuuming intensity dimi-
nishes while you are working, read "IMPRO-
VING THE VACUUMING CAPACITY".
The machine is fitted with a mechanical device (float) under the vacuum lid. When the collection tank is
full, this device shuts off the air to the vacuum motor to protect it; you will recognise this condition by the
deeper noise made by the motor. When you hear this sound, you must empty the collection tank (read
"EMPTYING THE COLLECTION TANK").
21