Dry Vacuum Cleaner - Hillyard Trident WD21V Manuel D'utilisation

To start working, proceed as follows:
1.Make all the checks indicated in "PREPARING THE MACHINE".
2.Free the vacuum head from the collection tank by releasing the hooks (1) on the side of the tank.
Rotate the levers as shown by the arrow in the picture on the right.
3.Use the handle (2) on the vacuum head unit to remove it from the collection tank.
4.Rest the head carefully on the ground.
5.Remove the float unit from the collection tank.
ATTENTION: if you are using the paper
filter/collection bag, read "INSERTING THE
FILTER/COLLECTION BAG".
6.Use the handle (2) on the vacuum head unit to position it above the collection tank.Make sure the
machine's power supply cable is in the rear part of the tank.
7.Fix the vacuum head to the collection tank by coupling the hooks (1) on the side of the tank. Rotate
the levers as shown by the arrow in the picture on the right.
8.nsert the plug (3) of the power cable (4) in the mains socket (5).
9.Switch on the machine by bringing the main switch (6) to the work position "I".
10.Carry out the cleaning work.

DRY VACUUM CLEANER

ATTENTION: if the vacuuming intensity dimi-
nishes while you are working, read "IMPRO-
VING THE VACUUMING CAPACITY".
19