Float Components (For Vacuuming Liquids); Vacuum Head Components; Machine Safety - Hillyard Trident WD21V Manuel D'utilisation

FLOAT COMPONENTS (FOR VACUUMING LIQUIDS)

The float kit components are:
1.Float
2.Sponge filter

VACUUM HEAD COMPONENTS

The vacuum head components are:
1.Main switch
2.Vacuum head lifting handle bar
3.Vacuum filter cleaning button
4.Power supply cable
5.Power supply cable support hook
6.Vacuum filter

MACHINE SAFETY

To ensure that work is carried out in the best safety condi-
tions, proceed as follows:
1.Make sure the collection tank is empty. If this is not the
case, empty it (read "EMPTYING THE COLLECTION
TANK").
ATTENTION: the place designated for this
purpose must comply with the current envi-
ronmental protection regulations.
2.Make sure the main switch (1) is in the idle "0" position; if
not, turn it to this position.
3.Make sure the plug (2) on the power supply cable (3) is
disconnected from the mains socket (4). If necessary, discon-
nect it.
ATTENTION: to avoid damage to the mains,
disconnect the plug (2) from the socket (4) by
pulling directly on the plug (2) rather than the
cable (3).
PREPARING THE MACHINE
12