Technical Data; Power Supply - CST/BERGER LM800 Série Notice Originale

Technical Data

Rotational Laser Level
Article number
Plumb beam, upward and downward
Point Operation
Line Operation
Inclination operation
– single axis without remote control
– dual-axis with remote control
Working range (radius) with laser receiver, approx.
Levelling accuracy
– in horizontal position
– in vertical position
Self-levelling range, typically
Levelling duration, typically
Rotational speed
Operating temperature
Relative air humidity, max.
Laser class
Laser type
Laser beam Ø at the exit opening, approx.
Tripod mount (horizontal and vertical)
Battery pack (NiMH)
Operating life time, approx.
Weight according to EPTA-Procedure 01/2003
Dimensions
Degree of protection (excluding battery compartment)
1) alongside the axes
Please observe the article number on the type plate of your measuring tool. The trade names of the individual measuring tools may
vary.
For clear identification of your rotational laser level, see the serial number 14 on the type plate.
Assembly

Power Supply

Inserting/Removing/Changing the Battery
Pack
Insert the supplied battery pack 17 into the battery
compartment in such a manner that the labelling
"Install this side down" faces downward. Allow the
locking knob of the cap 18 to engage in the housing
of the measuring tool.
To remove the battery pack 17, press the locking knob
outward and pull out the battery pack out of the bat-
tery compartment.
When the battery pack 17 is to be replaced, pull off
the cap 18 of the battery pack to the side and slide in
a new battery pack. Pay attention that the locking
knob on the battery cap is on the same side as the
labelling "Install this side down".
800.561.8187
22 | English
1)
www.
LM800GR
F 034 K61 9NG
425 m
± 0.05 mm/m
± 5° ( ± 8 %)
600 min
– 6 ... +49 °C
650 nm, <1 mW
5 mm
1 x 7.2 V (2600 mAh)
2.5 kg
203 x 159 x 162 mm
Remove the battery pack from the measur-
ing tool when not using it for longer periods.
When storing for longer periods, the rechargeable
batteries can corrode and discharge themselves.
Charging the Battery Pack in the Measuring
Tool
Charge the battery pack 17 before using for the first
time. The battery pack can only be charged with the
battery charger 24 provided. For charging, the battery
pack must be inserted in the measuring tool.
Connect the appropriate charge cable for your mains
supply to the battery charger 24.
Switch the measuring tool off. Insert the charger plug
25 of the battery charger into the socket 16 on the
measuring tool. Connect the battery charger to the
mains supply. Charging the empty battery pack takes
approx. 8 h. The battery charger and the battery pack
are protected against overcharging.
information@itm.co
.com
LM800DP
F 034 K61 9NE
–
–
–
± 0.05 mm/m
± 0.1 mm/m
–
± 5° ( ± 8 %)
30 s
-1
150/300/600 min
– 6 ... +49 °C
90 %
2M
635 nm, <1 mW
5/8"
1 x 7.2 V (2600 mAh)
15 h
203 x 159 x 162 mm
IP 67
2 610 A15 117 • 12.8.09
425 m
30 s
-1
90 %
2M
5 mm
5/8"
15 h
2.5 kg
IP 67