Adjusting The Driving Speed; Using The Horn; The Status Indicator; Using The Joystick - Vermeiren LiNX 200 Mode D'emploi

Commande intégrée dans le fauteuil roulant électrique
Masquer les pouces Voir aussi pour LiNX 200:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12

Adjusting the driving speed

Fast
Slow

Using the horn

Press the horn button (located above the joystock). The horn shall sound as long
as the button is pressed.

The status indicator

The status indicator is integrated in the ON/OFF button. When the LiNX 200 system
is not powered up, the status indicator is not lit.
When the LiNX 200 system is powered up, and there are no faults with the system,
the status indicator will be lit green.
If, when powered up, there is a fault with the system, then the status indicator will
flash red. The number of flashes will indicate the type of error. For flash codes refer
to paragraph 2: Troubleshooting.

Using the Joystick

Moving the joystick will drive the electric wheelchair in that direction. The amount of
joystick movement will determine the speed that the powerchair will move in that
direction.
Make sure that the joystick is in the neutral (central) position when pressing the
on/off button, otherwise the electronics will be locked. To take this block away let
go the joystick until he goes back in neutral position.

Drive inhibit indication

The speed switch allows the user to limit the maximum speed of
the wheelchair (that is the speed when the joystick is fully
deflected) their preference and environment.
The speed switch offers 10 discrete steps between the lowest
speed (switch to the left) and the highest speed (switch to the
right).
As a visual reminder, a speed symbol is positioned above the
speed switch to indicate the low and high positions.
Drive inhibit mode is indicated by the battery charger
Chase 1
indicator with a right-to-left chase sequence.
The chase sequence starts with the green LED on the
Chase 2
right-hand side, and by one-by-one, each LED will
switch on and then off. When the sequence completes
at the left-most red LED, it begins again at the
Chase 3
righthand side.
The chase sequence continues until the error
Chase 4
condition has been cleared.
Chase 5
5
LiNX 200
vA - 2016-09

Publicité

Table des Matières
loading

Table des Matières