Dometic SEITZ Instructions De Montage Et De Service page 18

Fitting the blind
➤ Pre-drill the fixing holes with a drill that has a diameter of 2 mm (fig. 5,
page 5).
➤ Fix the roller blind cassettes using the supplied screws to the wall of the
vehicle (fig. 6, page 6).
3.1 Shortening the guide rails
If the guide rails are too long, they can be shortened as follows:
Measure the length of the guide rails (fig. 7, page 6)
➤ Determine the length of the guide rails by holding the roller blind cassettes
against the upper and lower edge of the window (2).
The handle strip (1) should not project into the clear height F of the win-
dow cut-out.
➤ Measure the dimension B between the surface stops of the mortises and
tenons (3).
Cutting the guide rails to length (fig. 8, page 7)
A
NOTICE!
Saw both guide rails off square and to equal lengths.
➤ Saw the same end of both guide rails (with the same distance to the slots)
to the length of dimension B.
➤ Use the waste pieces to measure the length B1 from the slots to the end
of the pieces.
➤ Deburr both guide rails.
➤ Use a 2-mm drill to pre-drill new slots at the distance of B1 from the new
end of both guide rails.
➤ Make the pre-drilled holes into slots (1).
18
Dometic
EN