Abicor Binzel ABIPLAS CUT 200 W Mode D'emploi page 45

®
ABIPLAS CUT 200 W/MT
6.3.2 Filtered compressed air free of oil and water
6.3.3 Plasma-cutting torch with a central connector
Use only compressed air which is free of dirt, oil and water.
We recommend:
• Initial filter with a 5 µm pore size
• Sub-micro filter with a 0.01 µm pore size
• 99.99% oil separation rate
• Air throughput at a flow pressure of 3.5 bar:
®
ABIPLAS CUT 200 W and
®
ABIPLAS CUT 200 W MT: >35 l/min
 Tab. 3 Product-specific torch data (EN 60 974-7) on page EN-9
The plasma-cutting torches with a central connector must be connected only to
power sources with central sockets which comply with the safety requirements
established in EN 60974-1 and EN 60974-7.
NOTICE
• The assignment of the cutting torch and cutting power source is clearly
defined by the codes on the plug and the socket and must be observed
under all circumstances.
6 Putting into operation
EN - 19