Accessories - Abicor Binzel ABIPLAS CUT 200 W Mode D'emploi

®
ABIPLAS CUT 200 W/MT

6.1.1 Accessories

Torch carriage set
Torch carriage
Spacer
The choice of plasma nozzle is determined by the thickness of the material to
be cut and the current intensity.
 Tab. 5 Selection of plasma nozzle on page EN-10
5 Screw on the protection cap hand tight.
• The torch carriage makes it possible to cut circular parts in the diameter
range of approx. 100 to 1000 mm with the ABIPLAS
manual torch.
• The torch carriage is clamped to the protection cap.
NOTICE
• When tightening the set screw on the clamp, ensure that the protection
cap is not subject to excessive pressure, damaging the female thread.
Fig. 3 Torch carriage ABIPLAS
• Without circular guide
• Distance spring
• Bevel nozzle
• Hole piercing cap
6 Putting into operation
®
CUT 200 W
®
CUT 200 W
EN - 15