Operation; Cleaning - Proficook PC-HGA 1111 Mode D'emploi

CAUTION: Overload!
• When using extension cords, these should have a
cable cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance
is too powerful.
Power On / Off
Power on:
Turn the temperature control (10) clockwise to the
desired temperature.
Switch the On / Off Switch I/O (7) to position I. The
control light in the On / Off Switch I/O (7) lights up red.
NOTE:
Depending on the ambient temperature and the
content that is being heated in the tank, differences
between the set and the actual temperature can
occur.
To turn off:
Switch the On / Off Switch I/O (7) to position O. The
control light in the On / Off Switch I/O (7) turns off.
Turn the temperature control (10) counterclockwise as
far as it will go to the position °C.

Operation

Heating and Keeping Warm:
1. Fill the appliance with the desired beverages.
Minimum filling level 3 liters.
2. Insert the mains plug (12) into the socket.
3. Before use, turn the lid (2) and lock it with the lock
mechanism of the lid (3).
4. Turn the temperature control (10) clockwise to
WARNING:
• Always turn the appliance off before cleaning and disconnect the
power plug (12). Wait until the appliance has cooled.
• Never immerse the appliance into water or other liquids.
• The appliance is not suitable for cleaning with a jet of water. There-
fore, do not clean this appliance with a pressure water jet!
• Clean the appliance regularly.
the desired temperature. The temperature control
(10) can variably adjust the temperature between
approx. 30°C - 100°C.
5. Switch the On / Off Switch (7) to position I. The red
Power control light (7) and the red heating control
(9) light are turned on.
6. When the set temperature is reached, the heating
control light (9) switches off and the green "keeping
warm" control light turns on; the appliance remains
in "keeping warm" state and holds the set tempera-
ture until it is switched off.
7. In order to drain liquid, pull the tap (11) up or push
it down and hold it in this position, until the cup or
tank is filled. Release the tap (11) after the tapping
process, it shuts off automatically. For a steady
flow, push the tap (11) up or down until it locks,
after overcoming a slight resistance; the tap (11)
remains open.
8. Due to the system, a residue of approx. 1.5 l of
liquid remains in the tank (1). This amount can be
reduced by cautiously tipping the tank (1) forward
while draining the liquid.
Pause Operation / End Operation:
• Switch the On / Off Switch I/O (7) to position O to
end the heating or boiling process.
• Turn the temperature control (10) counterclockwise
as far as it will go to the position °C.
WARNING: Hazard of burns!
• The housing will be hot during use, do not touch
and let the appliance cool down before storing it.
• Disconnect the mains plug (12).

Cleaning

43