Remote Control Features - Danby DVAC10038EE Manuel D'utilisation

DVAC8036 FINAL OM-.qxp 2006.02.23

Remote Control Features

Electronic Display: Displays the following
information;
A: Remote Control Power (On/Off) and Mode Icons
B: Clock and Auto-Timer settings
C: Current set temperature
D: Fan speed setting
Control Buttons
1. Power switch.
2. Mode
3. Fan Speed
4. Energy Saver
5. Auto-Timer
6. Used to increase
settings in 1° increments on the Celsius or
Fahrenheit scale. When adjust the timer or timer
settings in 1 minute
7. Cancels current Timer ON/OFF settings.
8. Lock prevents the remote control settings from
inadvertently being changed.
9. Clock: Depress the button for 3 seconds in order
to set the clock. Press the increase or decrease
arrow to adjust the clock in 1 minute intervals,
holding down the increase or decrease arrow will
adjust the time in 10 minute intervals.
10. Used to activate the SLEEP program.
11. Toggle the LCD backlight on/off.
12. Restore remote control default settings.
17:08 Page 14
or decrease temperature
Electronic
Display
B
2
4
6
8
10
To operate the hand held remote control will require
two "AAA" Alkaline batteries (included ).
Batteries should be replaced when:
a) No signal (beep) is heard when attempting to
program the main unit.
b) The main unit does not respond to a command
issued by the remote control.
Battery replacement:
1. Slide the rear cover on the remote in the direction
of the arrow. Continue pulling (gently) until the
cover separates completely from the unit.
2. Insert (2) batteries (AAA) following the same
orientation (polarity) depicted inside the battery
chamber.(+/-)
3. Re-install rear cover.
4. If the remote control will not be used for extended
periods of time (vacations etc.), batteries should
be removed.
The remote operates within a range of 8 meters
(26 ft.) from the receiver located inside the main unit.
Any obstruction between the receiver and remote
may cause signal interference, limiting the ability to
program the main unit.
6
A
C
1
D
3
5
7
©
9
11
12