Location And Connection; Set-Up And Operation - EUROM EK2K Still Manuel D'utilisation

Description
1. housing
2. grip
3. hot air discharge grille
4. control knob
5. thermostat knob
6. frame
Internal: PTC element and
fan
The heater's direction of radiation can be
adjusted from straight ahead to straight up using the grip (90°).
The control knob of the EK2K Still & EK3K Still has 4 settings:
From top to bottom:
The Thermostat knob is freely adjustable.

Location and Connection


Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
 Choose a suitable location for the heater which is at least one metre away from
any obstructions, walls or inflammable materials (see also safety instructions).
Always ensure that the heater has sufficient space at the back to suck in air and
at the front, to blow out hot air (1 metre). Make sure the heater is always in an
upright position on a solid, flat, horizontal and non-flammable surface.

Check if the control switch is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V socket. To prevent
the circuit overloading, check that no other appliances are connected to the same
group.

Set-up and Operation

If the heater is being used for the first time (or if you want to reset the desired
temperature), turn the thermostat dial to the maximum position (clockwise as far as it
goes).
With the mode selector dial, adjust the heater to suit your preferences: fan only, low
power or high power. It is most economical to heat the space at full power, then to
switch to half power to maintain the temperature.
Both at half and full power, the fan rotates at the same speed; the difference between
the two lies in the number of heating elements in use.
- O (off)
- ventilate only
- low power
- full power
18