Explanations To The Statuses Of The Signal Inputs, Output Contacts And Led's - Camille Bauer SIRAX SV 824 Mode D'emploi

Configuration switch:
Direction of action A1
1
Direction of action A2
2
Input monitor
OFF ON
Yellow LED 1 Status display of
1 2
relay A1
Yellow LED 2 Status display of
relay A2
ON
Red LED 3 Open and short-circuit monitor
Camille Bauer AG
(both inputs)
CH-5610 Wohlen
Switzerland
Green LED 4 Device standing by
SIRAX
SV824
Fig. 6. Locations of the configuration switches and LED's.
Explanations to the statuses of the signal inputs,
output contacts and LED's
Signal inputs S1 and S2
means: "Closed"
(mechanical) contact
with parallel resistor
or
"Undamped"
sensor in
control circuit
means: "Closed"
(mechanical) contact
with parallel resistor
or
"Damped"
sensor in
control circuit
Output contacts A1 and A2
A1
c27 c29 c31
a26 a28 a30 A2
Relay de-energised
= status with power
failure too
INV/NORMAL
INV/NORMAL
OFF/ON
1 to 2 kΩ
10 to
15 kΩ
1 to 2 kΩ
10 to
15 kΩ
c27 c29 c31
a26 a28 a30
Relay energised
LED displays LED1, LED 2 and LED 3
means: "Off" ( status with power failure too)
means: "On"
Table 4: Function behaviour to connection of sensors
according to DIN EN 50 227 or mechanical contacts with
one parallel and one series resistor
Control Signal LED
circuit inputs display
(red)
S1 and S2 A1 and A2
LED 3
Status Status
A1
A2
(1)
(1) No influence
* Where mechanical contacts are used without a parallel
and series resistor, the switch "
input must be switched to "Off" (to the left
settings for the logic are the same as for "normal
operations".
Signal input monitoring
The switching amplifiers can be supplied with a device for
monitoring the signal inputs.
This monitoring device consits of the red LED display LED3.
It signals a short circuit and/or a break in the signal input lines.
The statuses of the LED3, output contacts A1 and A2 and
LED1 and LED2 are given in Table 4 for a short or open-circuit
in relation to normal operation.
In order to make the input circuit monitor active, place the
configuration switch marked "
right ).
Fig. 6 shows the arrangement of the switch "
Note: With switch amplifiers acting together with (mechanical)
contacts in the control circuit, these contacts must be
preceded by resistors: one parallel resistor of 10 to 15 kΩ,
one series resistor of 1 to 2 kΩ (see Fig. 7).
1 to 2 kΩ
Mecha-
10 to
nical
15 kΩ
contact
Control circuit
Fig. 7
Output LED Configuration
contacts displays switch
(yellow)
"1"
and
LED 1
"2"
and
Status
LED 2
Status
C27 C29 C31
C26 C28 C30
(1)
" for monitoring the
). The
" in the "ON" position (to the
".
R ≤ 200 Ω
Ltg
SIRAX SV 824
19